ANTI-SQUEAKING SPRAY

279911

Dry surface lubricant for treating mechanical parts made of metal and plastic e.g. folding roofs, door locks, slideways, seat tracks, seat belts, windscreen wipers, zips and oven hinges.

QUALITY AND PROPERTIES
Leaves behind pure PTFE, no grease or oil (dry film)
Very low friction coefficient
Excellent adhesion
Prevents wear and clamping
Suitable for parts that are exposed to light loads and/or low speeds.
Also suitable as an anti adhesive for injection moulds that are not allowed to come
into contact with silicone (release spray).
Directed jet spray
Special valve allows applicaton in any position (360° valve)

PHYSICAL AND CHEMICAL DATA
Basis: Polytetrafluoretheen
Colour: white-transparent
Appearance: white powder
Yield: 1.74 g/sec.
Vapour pressure at 20°C: 3 to 4 bar
Particle size: 5 µm
Drying time (at 23°C, 50% relative air humidity):
Drying approx. 5 minutes The drying time depends on surrounding temperature, air humidity and thickness of the applied coat.
Temperature resistance: -50°C to +250°C
Storage stability: 10 years if appropriate storage provided (=10° to 25°C, relative air humidity of max. 60%)
Size: aerosol can, maximum nominal volume 400 ml

ENVIRONMENT AND LABELLING
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as special refuse.
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
USING INSTRUCTIONS
Before use, carefully read and observe the warning texts on the label!
Application:
Bring the can to room temperature.
Optimal operating temperature 5° to 30°C.
Shake can vigorously before use.
Apply presto PTFE Spray dry in a thin even layer.
A dry PTFE film is left after evaporation (approx. 1 minute).
TIPS FOR SPRAY PAINTING
Protect the object and the surrounding area from spray mist. Temperature should range between +10°C and +25°C, max. air humidity 60 %.
Store in a dry place. Protect from direct sunlight and other sources of heat. Use only during dry weather, in places protected from the wind, and in well-ventilated rooms. Follow the warning texts on the labels!