presto Anti-Squeaking Spray prevents annoying squeaking of brakes that occur between the brake caliper piston or bearing points and brake pad.
It safeguards the entire brake system and provides addition corrosion protections.
Metal-free, therefore suitable for lambda sondes.
Suitable for ASR and ABS brake systems.
QUALITY AND PROPERTIES
Extremely good adhesion
Contains calcium-fat and lithium-fat with titaniumdioxide
Prevents brakes from squeaking
High thermo stability
Good corrosion protection
Resistant to chemicals and effects of weather
Resistant to water, salt, and weak acids and alkalines
Directed jet spray
Sprayable from any angle due to a special 360 valve
TRG 300 compliant
PHYSICAL AND CHEMICAL DATA
Basis: EP-2 Grease
Relative density at 20C: 1.11 g/ml
Yield: 1.5 g/sec.
Vapour pressure at 20C: 3 to 4 bar
Temperature resistance: -30C to +180C
Storage stability: 10 years if appropriate storage provided (=10 to 25 C, relative air humidity of max. 60%)
Size: aerosol can, maximum nominal volume 400 ml
ENVIRONMENT AND LABELLING
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as special refuse.
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Before use, carefully read and observe the warning texts on the label!
Bring can to room temperature.
Operating temperature 5 to 30Â°C.
Cover coated and plastics parts.
Shake for 2 minutes before use.
Clean areas to be treated of moisture, dirt and grease.
Before assembling brake parts, spray them evenly and then leave to dry. (Anti-Squeaking Spray can be removed with presto Brake Cleaner.)
Make sure not to spray brake discs and blocks!
TIPS FOR SPRAY PAINTING
Protect the object and the surrounding area from spray mist.
Temperature should range between +10Â°C and +25Â°C, max. air humidity 60 %. Store in a dry place. Protect from direct sunlight and other sources of heat. Use only during dry weather, in places protected from the wind, and in well-ventilated rooms. Follow the warning texts on the labels!